Page 1 of 1

Full Spectrum Laser - Pegasus Touch 3D printer

Posted: Fri May 19, 2017 12:31 pm
by mightynova63
I just cam across a Pegasus touch printer and am wondering if any one else is using the same or similar printers. This is my first SLA printer, any help or tips would be great. Im not even sure yet if i can use the SIMPLIFY software yet.

Re: Full Spectrum Laser - Pegasus Touch 3D printer

Posted: Tue May 23, 2017 11:03 am
by kabali16
Simplify3D by default supports only FFF printers. Using SLA is a bit tedious but possible by using post processing commands to replace E with Laser on or OFF