dang8
Posts: 1
Joined: Fri Aug 18, 2017 2:12 pm

CubeX with CubeItMod

Sat Aug 19, 2017 3:32 pm

Hello,
Has anyone been able to get the CubeX working with CubeItMod so we can use aftermarket filament? I see that Simplify3d supports the CubeX, but only with the cartridges. Sadly, the cartridges are way out of my budget and a little difficult to get a hold of.

There were a few posts on here, but they seem to get to a point and leave you hanging. I'm using firmware 1.07 on my CubeX, and don't know all that much about GCode. :?:

Return to “General Discussion and Tips”