Posts: 4
Joined: Tue Sep 05, 2017 1:23 am

Problems calibrating my extruder

Tue Sep 05, 2017 1:47 am

So I have a Winbo SH155L printer that seems to be running marlin firmware (not sure how to check this).

I tried calibrating my extruder with the help of youtube tutorials, but I am unable to get the extruder to extrude 100 mm of filament.

I tried adjusting the E steps/mm (I did all the math) many times and the amount extruded seems to be random and cannot be calibrated.

The command was given on the LCD controller ( moveaxis by 1 mm), Extruder and then i selected a value of +100 with a temp of 210C.

I kept saving the new E steps/mm value and doing the test again but the results seem to be random and I am unable to get it right.

What am I doing wrong? Should I print a Gcode file for this test? Should the commands be given though the USB cable from my PC (if so can this be done with S3D?


Return to “General Discussion and Tips”