According to the printer compatibility page, Simplefy3D has a configuration for the M3D Micro Pro. So it seems, but does anyone know how to print the output gcode on the Pro? I've tried several ways but they all disconnect once the hotend reaches temperature. Thanks.
I have the same problem...
I try conect Simplify to printer, without succes.
I try export gcode and send to printer throgh the M3d Software. fail again.
We also bought this for a machine that was "Supported" a SINDOH WOX3D1. In the end we could only load onto the SD card and print that way. IMHO it defeated the whole purpose of paying 150.00 for a piece of software. So what they consider "Supported" might not be what you think.
Because we used a hard network connection we could not use the soft to directly print files. They had to be transferred to an SD card.