Page 1 of 1

Z hop when retracting

Posted: Tue Feb 13, 2018 8:20 am
by francoisyft
Hi,
I'm a new user with simplify3D, and I looking for the setting "Z hop when extracting" in simplify3D. I use this parameter in cura for my kossel linear plus and it's better, it's a parameter is recommended on delta printer.

If some one can say me where I can find a similar setting in simplify3D , it will be the perfect sofware for me.

Ps: sorry for my english...

Re: Z hop when retracting

Posted: Tue Feb 13, 2018 12:04 pm
by dkightley
Are you looking for a Z hop when retracting? If so, it's Retraction Vertical Lift.