airsyspro
Posts: 11
Joined: Thu Jun 18, 2015 12:48 pm

Print Quality Issue

Sun Apr 22, 2018 11:42 am

As can be seen in the picture below I am getting a ribbing effect on a part I am printing No matter what angle I rotate the part for the print, I get the same results in the same area. The other side of this part which 180 degrees opposite turns out almost flawless.

This orientation is that the Top of the picture is the top of the print.

As one can see in the right side of the picture, the ribbing effect disappears

Any Help would be appreciated.

Larry
Print issue.JPG

Return to “General Discussion and Tips”