Nozzle too far away from bed
Every time I start a print the nozzle is starting over 6mm from the bed. I adjusted the setting in the Z-Axis global G-Code Offset but it does not change.
Re: Nozzle too far away from bed
This may not sound like a helpful request, but please define what your definition is for "starting". And how are you determining that its 6mm above the bed?
Doug Kightley
Volunteer at the National Tramway Museum http://www.tramway.co.uk
Railway modeller and webmaster at http://www.talkingtgauge.net
Volunteer at the National Tramway Museum http://www.tramway.co.uk
Railway modeller and webmaster at http://www.talkingtgauge.net
Re: Nozzle too far away from bed
On the advanced tab has the "start printing at height" been enabled?
