Re: simplify3d does not add a brim, skirt or raft to model
I would flip the gear over so the side with the slim boss is uppermost.....otherwise the finish on the bottom will be not very good as the first layer of the main gear wheel will be printing over fresh air!
Doug Kightley
Volunteer at the National Tramway Museum http://www.tramway.co.uk
Railway modeller and webmaster at http://www.talkingtgauge.net
Volunteer at the National Tramway Museum http://www.tramway.co.uk
Railway modeller and webmaster at http://www.talkingtgauge.net
-
ourfriendandrew
- Posts: 1
- Joined: Tue Apr 06, 2021 7:33 pm
Re: simplify3d does not add a brim, skirt or raft to model
If you previously used a split process, it has an issue where it remains "Start printing at height"
So go to the advanced tab, and make sure that box is not checked. I noticed this happened and
my printer was starting the print at 1mm because of previous settings, bypassing the raft layers
So go to the advanced tab, and make sure that box is not checked. I noticed this happened and
my printer was starting the print at 1mm because of previous settings, bypassing the raft layers
