Slick36
Posts: 1
Joined: Wed May 30, 2018 10:55 am

Connecting to Anet A6

Sun Jul 15, 2018 9:42 am

Just finished putting together my new Anet A6. Ohter than bed leveling which is another issue, I can't seem to get Simplify 3D to connect. Them COM port (com6 on my machine) shows up as RAMPS.

I've set the printer to Anet A6 in the software and the baud rate to 9600 in both the port and software but still no banana.

Any advice?

BTW, it works PERFECTLY with my Davinci Jr Pro. Worth every penny.

sydtoon
Posts: 1
Joined: Wed Oct 24, 2018 12:46 pm

Re: Connecting to Anet A6

Wed Oct 24, 2018 12:58 pm

I have the same problem with my Anet A8, Simpllify3d said it was supported on installation but has never worked. I still have 13 days to claim a refund and this not sorted that is what I intend to do. Simplify support is unsupportive.

Return to “Troubleshooting and Bug Reports”