Using the Bridging Fan Speed Override setting in the 'Cooling' tab is not working for me.
However if I set the cooling on for the whole print the fan does run, so the physical fan control is fine...
I'm printing in ABS so using fan during normal layer printing is not what I want (it causes weak layer bonding and other issues), I just want the fan on during a bridging layer and setting this 'on' in cooling is not achieving that.
I also notice in the model layer speed preview that the bridging layer colour is the same as the normal layers below, indicating same speed applied as them.
Anyone else got this issue or issues ?
Using S3D V4.0.1