This will not slice. Suggestions?

[nerys]

Pretty sure its thin wall extrusion that is causing it but "I WANT" that on for this particular print.

any suggestions? factory file attached. I left it for 6 hrs it will not slice it.

https://drive.google.com/open?id=1JevVQ ... e957uWmIXK

can not attach file error file too large so I put it on google.

[blackbird2016]

Slices quite well in fractions of a second.

[nerys]

I could only make it slice by turning off thin wall. then it sliced as you noted. in seconds.

[dkightley]

I've done a few tweaks to your profile. Try and see if my version slices......