thepolekat
Posts: 2
Joined: Sat May 24, 2014 10:05 am

Saving as .x3g vs. .gcode

Sat May 24, 2014 12:13 pm

My FlashFroge Creator X (Dual) will not see .gcode on the SD card. Is there a way to get SD3 to "Save Toolpaths to DisK" as .x3g and not as .gcode?

MasterFX
Posts: 206
Joined: Tue May 20, 2014 10:23 am

Re: Saving as .x3g vs. .gcode

Wed Jun 04, 2014 12:57 pm

Check the Process Settings under Scripts.
If you enable the Checkbox the x3g and gcode are placed in the same directory
Attachments
FFF Settings.png

User avatar
TenKOhms
Posts: 172
Joined: Wed May 14, 2014 2:04 pm

Re: Saving as .x3g vs. .gcode

Sun Jun 08, 2014 10:01 am

Make sure you have the correct profile selected in the FFF process settings as well. Any printers that use the .x3g files should already have the checkbox MasterFX referred to pre-checked in their respective profiles.

Return to “Troubleshooting and Bug Reports”