titanbloom wrote: ↑
Sun Sep 02, 2018 5:10 pm
Can you clarify what you mean by X and Y axes are off? Is the software trying to goto coordinates that are out of your work area?
Sorry, I Zero all of the Axis then perform the Leveling Wizard. It will move on the X axis by about an inch (still on the bed) the second move it moves to the opposite corner about an inch or so off of the bed. The same thing happens when I try to print, it thinks it's bed is an inch farther than the Zero axis. The picture is to show how far it thinks it is off. Not sure if this is a Firmware issue or a Software issue
. Not sure how to test.