alien2108
Posts: 16
Joined: Fri May 23, 2014 2:41 pm

Interesting slice of bridge test

Tue May 27, 2014 3:51 pm

I was just about to use the bridge test model and Simplify3D decided, that the part that should be fully bridged will actually just have both sides bridged and the rest infilled :)
bridge.png
Model, slicer or my problem? :)

AndersE
Posts: 220
Joined: Sun Feb 02, 2014 4:40 pm

Re: Interesting slice of bridge test

Tue May 27, 2014 5:32 pm

Same for me, but isn't that good? Why should it bridge all?

User avatar
jimc
Posts: 1124
Joined: Wed Aug 28, 2013 10:02 pm
Location: mullica, nj
Contact: Website

Re: Interesting slice of bridge test

Tue May 27, 2014 5:48 pm

from what i have noticed is that it will bridge the outer perimeters then try to do short and not full extrusion strands to connect the 2 walls. they usually end up as very fine little strings and not a full normal infill. i could be wrong with this but i have seen it in the past and it does have an interesting way of bridging but it works.

Return to “Troubleshooting and Bug Reports”