-
mikedehaan
- Posts: 15
- Joined: Mon Nov 28, 2016 12:27 am
[Solved] Strange layer during preview
Simplify 3d is generating a weird anomaly at layer 149. For some reason it is inverting a wall and stretching it clear to the other side of the model. I tried the same model in Cura with no such error. I do not own this model and cannot make changes, but since there is no error in Cura, I figured this must be a slicer issue.
- Attachments
-
- sunPLA_0.6mm_0.2layer.factory
- (460.56 KiB) Downloaded 130 times
Last edited by mikedehaan on Mon Sep 24, 2018 8:48 am, edited 1 time in total.
Re: Strange layer during preview
Se this thread: viewtopic.php?f=9&t=10879&p=44123&hilit ... der#p44123
Doug Kightley
Volunteer at the National Tramway Museum http://www.tramway.co.uk
Railway modeller and webmaster at http://www.talkingtgauge.net
Volunteer at the National Tramway Museum http://www.tramway.co.uk
Railway modeller and webmaster at http://www.talkingtgauge.net
-
mikedehaan
- Posts: 15
- Joined: Mon Nov 28, 2016 12:27 am
[Solved] Strange layer during preview
That did the trick. Thank you!
