Page 1 of 1

Second extruder offset

Posted: Tue Jun 03, 2014 4:32 pm
by MarcoG
Hello to all!
I'm Marco from Italy, i need a little help for configure the software, my printer configuration is:

Delta printer (like Rostock)
Two head
Ramps 1.4
Repetier firmware (last version)

Heads offsets are configured in firmware, h1 -10.8,0.0 h2 10.8,0.0

I can print with repetier and cura without any problem, but with simplify3d i can't configure the right offset, please help me!!!


Re: Second extruder offset

Posted: Wed Jun 04, 2014 6:39 pm
by bubbasnow
with repetier i set the offset in eeprom, then i just enable the second extruder in processes. if you type t0 and t1 in the command window you should see that it pulls offsets and applies them from eeprom