Hello, I'm a beginning with this software. Been using basic Makerbot Desktop for the last several years. This software has been like a whole new world. Who knew we could have this much control and print supports that don't destroy your model!
Anywho, I've done some successful printing but just now I set up two prints (two copies of Simplify3D open at once) and started them both with seemingly no issue. However, they both ended up printing the last print job that I had last week. So both printers were supposed to print two different models and neither of them printed the models I sent to them (via USB) and instead they both printed the previous job from last week.
Am I missing something here!
Any help is appreciated.