wangel
Posts: 1
Joined: Tue Oct 23, 2018 7:50 pm

Trying to print a go pro mount

Tue Oct 23, 2018 8:03 pm

So I've been trying for days to get this print dialed in.... and am having a TON of issues. I don't know what the problem is, so am looking for some guidance.

I am semi-new to 3d printing. I've had my printer since July.

The problem is the "curling" on the sides where the supports are. I don't get it =( I'm printing TPU at 230degree's the whole time. 60Degrees bed. 20mm/sec. I've tried printing it at 210degrees thinking it was too hot, and I tried Z-Hop to see if maybe that was it. No luck.

Here are some pics :)

Image
Image
Image
Image
Image
Image

Thanks everyone!

Return to “Troubleshooting and Bug Reports”