sassy_pants
Posts: 1
Joined: Wed Oct 24, 2018 8:51 am

Top Layer Not Completing

Wed Oct 24, 2018 8:55 am

I seem to have this issue with my settings on my printer, but I havne't been able to pin point it yet. When I have a noticeable top layer the printer seems to just stop with only a few lines left and acts like the print is complete and starts to activate the end settings where it pushes out the print and lifts the nozzle.

I'm not home at the moment but I'll post my end script when I get home, I just want to know if anyone else has had these issues before and what was done to resolve it.

Capture.PNG

Return to “Troubleshooting and Bug Reports”