No supports generated in hollow half-sphere

[GuyFromMars]

Hello,

I would like to print a cover for a ceiling lamp electrical interface to hide the loose isolated contacts from view. I made a model of a hollow half-sphere with a 10 mm flat ring to use double-sided glue tape to fasten it to the ceiling. As it turns out, Simplify3D doesn't seem to generate any kind of support for the middle part of the sphere. A hole opens and the print is ruined. I tried kinda all things that seemed possible, but the supports are not generated. Is that possibly a bug? I can send the model if that helps analyzing the issue. I use a raft.

[S3D-Alex]

Could you please include the model or Factory File for this?

[Codex404]

Without the model which Alex already requested its just guess work. My first thought is the "Only generate supports on the build platform" is enabled.

[horst.w]

To add support is no problem, it must be a setting issue perhaps also an issue with the model.

Factory-file will help ...



horst.w
GER