S3D-Alex
Posts: 151
Joined: Thu Aug 30, 2018 12:23 pm

Re: No retractions between printed support and perimeter?

Wed Nov 14, 2018 12:58 pm

charliedrums wrote:
Tue Nov 13, 2018 8:02 am
Factory File

https://fddusacorp-my.sharepoint.com/:u ... Q?e=genPdf
Thank you for providing the file! I was able to recreate this issue and have documented my findings and sent them to the development team.

I was able to work around this in the meantime by selecting the option "Force Retraction Between Layers" which can be found in the Ooze Control Behavior section of the Advanced tab of the Process Settings.

SweHogelid
Posts: 34
Joined: Wed Aug 03, 2016 7:01 am

Re: No retractions between printed support and perimeter?

Thu Nov 15, 2018 12:40 am

I did not have 'Force Retraction Between Layers' turned on, I never had that turned on other than experimenting and it introduced other problems like unnecessary retractions and it often leaves a blob.

But seriously, tried to upload gcode and got this response---> The file is too big, maximum allowed size is 3 MiB :lol:

Give me your adress and I'll mail you a thumb drive (just kidding)


Return to “Troubleshooting and Bug Reports”