dragonn
Posts: 17
Joined: Sat Nov 10, 2018 9:11 am

[FIXED] jerky movment on internal single extrusion

Sat Nov 10, 2018 9:23 am

On 4.1 my printer is doing really jerky movements when doing internal single extrusion, this causes my extuder to even loses steps. On 4.0 everything runs fine. Interesting is that the 4.1 gcode is much bigger then 4.0.
I attached factory file and both g-code files. Both file a sliced at exactly the same settings.
Attachments
4.1.gcode
(744.7 KiB) Downloaded 54 times
4.0.gcode
(108.45 KiB) Downloaded 49 times
jerky.factory
(3.36 KiB) Downloaded 53 times

dragonn
Posts: 17
Joined: Sat Nov 10, 2018 9:11 am

Re: [4.1] jerky movment on internal single extrusion

Fri Nov 16, 2018 4:34 pm

Any update? Confirmed?

S3D-Jake
Posts: 606
Joined: Wed Jun 20, 2018 12:45 pm

Re: [4.1] jerky movment on internal single extrusion

Wed Dec 12, 2018 2:43 pm

I’m happy to state that this issue with internal single extrusions should be resolved now in the latest 4.1.1 release. Our team successfully tested your jerky factory file presenting this issue in 4.1.0. As you can see in the visualization comparison posted below, 4.1.0 creates a much improved smooth corner effect when compared to 4.1.0. This was just one of many improvements to the software. All of which are detailed on our Release Notes page.
Visual Compare Internal Single Extrusions 410 > 411.png
Thank you for your help reporting this issue!
"A bird does not sing because it has an answer. It sings because it has a song."

Return to “Troubleshooting and Bug Reports”