I was attempting to create 2 process for this model https://www.thingiverse.com/thing:664004
The 2 processes was an attempt to create a little heavier bottom portion of the model.
These are the settings applied....
Process 1:
Layer height: .15mm
Bottom layers: 10
Top layers: 5
Infill: 60%
Start Printing: not set
Stop Printing: 11.4mm
Process 2:
Layer height: .15mm
Bottom layers: 5
Top layers 10
Infill: 10%
Start Printing: 11.4mm
Stop Printing: not set
Both processes selected when asked which ones to print.
The prepare to print preview shows there are no top layers being printed for process1 and no bottom layers being printed for process 2, the 10% infill of process2 starts directly on top of the 60% infill of process1 with no solid layers as per settings applied.
If I set process1 to print a solid diaphragm every 11.4mm, the preview shows that solid layer/diaphragm at the correct layer but 1 solid layer at that height isn't enough thickness to completely cover over and smooth the top layer of process1.
Has anyone else had these issues with multi-processes?
I gave up on that setup and just printed the whole model as one process with 30% infill because nothing I tried would insert those solid layers where I asked them to be.