BrandonJSpangler
Posts: 1
Joined: Fri Nov 23, 2018 9:58 pm

Dremel 3D20 Connectivity Issues - After Print

Fri Nov 23, 2018 10:06 pm

Hello Everyone!

I am new to 3D printing and also to Simplify3D, so I wanted to post my issue on here so that I can hopefully get some guidance. I am able to connect my 3D20 via USB and print from Simplify3D successfully one time. However, after I print anything, it seems like the software is losing connection to my printer.

Basically, if I want to print an item more than once, I need to completely shut the software down and restart in order to connect to my machine again. Without doing this, it seems to hang in a perpetual state of "printing" but isn't doing anything. I have tried going into some of the settings within the "machine control panel" but haven't had any luck getting it to connect again after forcing a disconnect. It's not a major issue, but it is a minor nuisance that I have to constantly shut the software down and restart when I am making a number of small prints...

Any thoughts?





Thanks!

Return to “Troubleshooting and Bug Reports”