Simplify3D User Forum

Using same Factory file (same profile, same STL). In version 4.1.0. if you have brim and two or more parts in STL file, brim in given cases between parts disappear.

S3D 4.1.0 - brim is wider than gap between parts → brim disappear →WHY? S3D 4.0.0 - brim is wider than gap between parts → brim fills the gap between parts → OK
Didn't tried version 4.0.1

Why in version 4.1.0 brim works this way? Is there possibility to switch of disappearing of brim?

I’m happy to state that this issue where the brim in between models would not be printed should be resolved now in the latest 4.1.1 release. Our team successfully tested many users' factory files from threads mentioning this issue. Your files should now in 4.1.1 have the brim filled in entirely between those models. This was just one of many improvements to the software. All of which are detailed on our Release Notes page.
Thank you for your help reporting this issue!