cornishmad
Posts: 4
Joined: Wed Feb 01, 2017 7:23 pm

GiantArm D200 issues

Sat Dec 08, 2018 8:56 am

Hi All,

Okay so yesterday I purchased the GiantArm D200 and checked S3D and they say its supported "Your Geeetech GiantArm D200 is supported!" Today I fork out £120 and nothing its not on the list by Geeetech?

Any advice

Thanks Ryan

rrdavis
Posts: 421
Joined: Sat Dec 09, 2017 4:52 am

Re: GiantArm D200 issues

Sat Dec 08, 2018 10:57 am

That probably just means they haven't rolled it out in the configuration assistant yet. Just email them and they will send it to you.
https://www.simplify3d.com/contact-us/

cornishmad
Posts: 4
Joined: Wed Feb 01, 2017 7:23 pm

Re: GiantArm D200 issues

Sun Jan 06, 2019 8:39 am

Okay so got the the Profile and no good, The bed does not lift fixed this in coding, The retention is way to much you can hear the cogs even with retention off?

Return to “Troubleshooting and Bug Reports”