Posts: 6
Joined: Wed Apr 25, 2018 5:28 pm

Simplify3d 4.1.1/ 3dlabprint issues

Sun Dec 09, 2018 3:12 pm

Im working on the PT-17 from 3dlabprint and i am seeing some issues with 4.1.1 On the PT-17 plane top wing part R and L 3 its like a layershift but it only did it to one part so i think its in the slicer sense it did not do it to both parts. they was being printed at same time and i only have the shift happen to one part and not the other? ... JVXlo612Ya

also the top wing R and L 4, and 5 out of noplace its adding outer line? ... XDrhJwMfut
this was sliced by 4.1.0 just fine.... the screenshot was using 4.1.1 that blue line that it wants to print is going to be a no go its in thin air and it should not be.

Posts: 6
Joined: Mon Mar 19, 2018 1:56 am

Re: Simplify3d 4.1.1/ 3dlabprint issues

Fri Mar 08, 2019 11:29 pm

I have issues with 3dlab prints as well. If you here anything please post it. I will do the same.

Posts: 400
Joined: Thu Aug 30, 2018 1:23 pm

Re: Simplify3d 4.1.1/ 3dlabprint issues

Wed Mar 13, 2019 9:42 am

Can you please post a Factory File showing this issue so we can investigate further?

Return to “Troubleshooting and Bug Reports”