I'm printing a Decora switch safety cover in white PETG, which requires supports. I just updated to 4.1.1 (from 4.0), so this is the first model I'm printing with the new version.
The supports run lengthwise:
However, the 4.1.1 "smart bridging" feature puts the first layer above the supports in the same direction as the supports:
This means there is a huge bridge in the "gaps" between the support structures. On PETG I end up with a bottom layer in this section with droops/strings and partially delaminated from the next layer up.
I'm going to try it with 4.0, where that first layer is at the 45 degree angle, but I anticipate it will work fine.
Is there any way to disable this "smart bridging" feature?