WarnerSmulp
Posts: 4
Joined: Fri Dec 21, 2018 3:01 am
Location: Panama
Contact: ICQ Website AOL Skype

Solved Leaves thick strings and lumps during printing

Thu Jan 17, 2019 11:51 am

Strange.. the day after I posted this and I did nothing it magically works. Refresh issue of some type maybe?
<a href="https://www.noriualaus.com/sanyo-3-cup-rice-cooker/">https://www.noriualaus.com/</a>

davorin
Posts: 26
Joined: Wed Dec 27, 2017 1:25 pm

Re: [Solved] Leaves thick strings and lumps during printing

Sun Jan 20, 2019 8:47 am

Let the printer work over night...seems I haven't tightened enough the PTFE tube in the heatsink...so it eventually popped out....cleaned everything inserted a new nozzle...and forgot to tighten the nozzle again after heating up.....so starting again from beginning (o;

If I want to replace the nozzle again I have to pull out the PTFE from the heatsink...where it is hold by a some sort of washer which prohibits pulling....

Guess I am ordering now a Swiss-Micro All-Metal hot end kit....

Return to “Troubleshooting and Bug Reports”