Print Quality from 0.7 Nozzle

[Oncology Engineer]

Hi All,

Thanks for the add.

I'm having terrible issues with the print quality from a 0.7 nozzle on a AON M2!

Whilst I have quite reasonable knowledge on 3D printers, the software I've previously used is Cura and Ideamaker, both using 0.4mm nozzles so I'm not sure what is the main cause.

I'd appreciate it if someone with large nozzle knowledge experience could look at my g code and pictures of a Thingiverse Simple Vase I printed and offer any suggestions including seam line removal and the overall quality.

I've attached the g code below.

Kind regards,

Adam