Okay, what the hell is going on with S3D. It will not turn on the hotend. It will preheat the bed but it wont turn on the hotend.
Here is the S3D starting Gcode
G90
M83
M106 S0
M140 S60
M190 S60
M104 S220 T0
M109 S220 T0
G1 X0.0 Y0.0 Z1.0 F1000.0 ; prepare to prime
G92 E0 ; reset extrusion distance
G1 Z0.2 F1000.0
G1 X60.0 E9.0 F1000.0 ; priming
G1 X125.0 E12.5 F1000.0 ; priming
G1 Z0.5 F1000.0
G92 E0 ; reset extrusion distance
M375
M376 H10
Here is the Heater section of Config.g for my printer
M307 H1 A1227.6 C324.8 D5 S1.00 B0 ;Heater 1 model
M570 S360 ; Hot end may be a little slow to heat up so allow it 180 seconds
M143 S385
; Fans
M106 P0 T45 H-1 ; disable thermostatic mode for fan 0
;M106 P1 T45 H-1 ; disable thermostatic mode for fan 1
;M106 P2 T45 H-1
; Tool definitions
M563 P1 P0 D0 H1 ; Define tool 0
G10 P0 S0 R0 ; Set tool 0 operating and standby temperatures
and this is the Error I get
T1
Error: M104: Invalid tool number
Error: M109: Invalid tool number
M25
Warning: Tool 1 was not driven because its heater temperatures were not high enough or it has a heater fault
and this is my extruder section in S3D
Can anyone help me with this?
Thanks