Hi everyone,
I just started using S3D at home and liked it so much I switched it over at our lab at work too. I have one main issue...less of a deal at home, more of a deal at work. Whenever I/we print with a raft, the part ends up being about half a mm tall in the Z axis. If I print the part without the raft, it's dead nuts on correct Z axis height. It does this with my Monoprice Maker V2.1 at home, and Ultimaker 3 and Ultimaker 2+ at work.
I'm assuming there's some sort of simple setting I need to adjust, can't find it though.
Ideas?
Thanks!
Dustin
Port Washington, WI