zemlin
Posts: 251
Joined: Mon Feb 01, 2016 11:36 am

Model Position Offets -9999.00

Sun Feb 10, 2019 8:30 am

Here's an issue I hadn't seen until 4.1.1
It only happens with some models. This one passed the repair checks so I think the model is clean. If I open the factory file in an older version they come up with the same offset, but I don't recall this happening when using those versions.
Capture.JPG
Factory file is attached.
Attachments
2019.02.10[PositionIssue].factory
(35.52 KiB) Downloaded 5 times

S3D-Jake
Posts: 420
Joined: Wed Jun 20, 2018 11:45 am

Re: Model Position Offets -9999.00

Mon Feb 11, 2019 11:11 am

Was this model created using mm as the unit of measure?
"A bird does not sing because it has an answer. It sings because it has a song."

zemlin
Posts: 251
Joined: Mon Feb 01, 2016 11:36 am

Re: Model Position Offets -9999.00

Mon Feb 11, 2019 11:34 am

No, modeled in inches. Thus the 2540 scale factor. The minor adjustments on the X and Y scale are calculated to account for machine and material behavior resulting in dimensionally accurate parts.

Return to “Troubleshooting and Bug Reports”