treyconley
Posts: 1
Joined: Fri Feb 15, 2019 3:59 pm

3D45 Doesn't Print Anything

Fri Feb 15, 2019 4:02 pm

I've been using Simplify3D with my Dremel 3D45 for a few months with no issues. I just updated to 4.1.1 and now I can't get my files to print. After the heating step, it says it's changing to printing but then the printer immediately ends the job with no errors. I saw the post about updating the profile using the configuration assistant and did that. I couldn't tell that anything at all changed. Any ideas?

Return to “Troubleshooting and Bug Reports”