tonyno
Posts: 166
Joined: Sat Jan 31, 2015 5:46 pm

Errant Stitching?

Thu Feb 28, 2019 10:24 am

See attachment. Where is this coming from and can I get rid of it? There is nothing that I can see that it is connecting.

s3d stitching.jpg
Attachments
keurig support.factory
(11.32 KiB) Downloaded 18 times

User avatar
dkightley
Posts: 2063
Joined: Tue Mar 10, 2015 4:09 pm

Re: Errant Stitching?

Thu Feb 28, 2019 10:52 am

First question first....its being caused by there being two solid layers set for the top surface. You are always likely to get these extra extrusions as the slicer tries to follow the rules you set where sloping edges are concerned.

Second question - use the Variable Settings Wizard to create a split that leave two layers in the top-most profile, then change the middle profile so there is only one top solid layer. Simples!
Doug Kightley
Volunteer at the National Tramway Museum http://www.tramway.co.uk
Railway modeller and webmaster at http://www.talkingtgauge.net

tonyno
Posts: 166
Joined: Sat Jan 31, 2015 5:46 pm

Re: Errant Stitching?

Thu Feb 28, 2019 8:06 pm

Interesting, and thanks.

Seems like that would be a third/fourth layer, though, but I will investigate.

tonyno
Posts: 166
Joined: Sat Jan 31, 2015 5:46 pm

Re: Errant Stitching?

Tue Mar 05, 2019 4:43 pm

Multiple top layers was the issue, but I had to set it to zero to get rid of it completely.

Return to “Troubleshooting and Bug Reports”