Page 1 of 1

Over-Extrusion and under-extrusion on print

Posted: Tue Apr 09, 2019 9:50 pm
by SailRabbit

I have recently switched from Cura to Simplify3d for the additional print quality, however I cannot remove this on my 3d prints.

The walls of the print seem to be perfect, but the "infill" area seems to be under-extruded on the top and over-extruded on the bottom. This only occurs near walls, though. Also, the print-head drags against the top surface and creates scars.

If anyone knows which settings affect this, please let me know, Thanks!

Top of Cube:

Bottom of Cube: