tonyeng
Posts: 1
Joined: Sat Jun 13, 2015 8:10 am

Re: Cannot remove internal supports when you have open the cross section view.

Wed Jan 01, 2020 6:49 pm

I have found this also - be very grateful if this can be fixed asap. I am trying to print a fan shroud MC2-B01 (from Thingiverse) but although I can add supports in a cross section view I can't remove the internal supports, which are blocking the air flow.

S3D-Alex
Posts: 308
Joined: Thu Aug 30, 2018 1:23 pm

Re: Cannot remove internal supports when you have open the cross section view.

Thu Jan 02, 2020 10:07 am

tonyeng wrote:
Wed Jan 01, 2020 6:49 pm
I have found this also - be very grateful if this can be fixed asap. I am trying to print a fan shroud MC2-B01 (from Thingiverse) but although I can add supports in a cross section view I can't remove the internal supports, which are blocking the air flow.
Can you please log into your account at Simplify3d.com, download the installer again and install that version to ensure you have the most up to date version?

ulisses
Posts: 1
Joined: Sun Apr 28, 2019 7:08 pm

Re: Cannot remove internal supports when you have open the cross section view.

Sat Jan 04, 2020 6:02 am

Any workaround on this?
I can't remove internal model supports.

S3D-Alex
Posts: 308
Joined: Thu Aug 30, 2018 1:23 pm

Re: Cannot remove internal supports when you have open the cross section view.

Mon Jan 06, 2020 9:54 am

ulisses wrote:
Sat Jan 04, 2020 6:02 am
Any workaround on this?
I can't remove internal model supports.
Have you tried the advice I suggested in the post above? Please log into your account at Simplify3d.com, download the installer again and install that version to ensure you have the most up to date version.

Return to “Troubleshooting and Bug Reports”