Sometimes, I get the attached message when I start-up S3D or when I try to load a factory file.
Is that a known bug?
Failed to parse XML
- Attachments
-
Re: Failed to parse XML
Doug Kightley
Volunteer at the National Tramway Museum http://www.tramway.co.uk
Railway modeller and webmaster at http://www.talkingtgauge.net
Volunteer at the National Tramway Museum http://www.tramway.co.uk
Railway modeller and webmaster at http://www.talkingtgauge.net
Re: Failed to parse XML
Thank you very much for your reply.
It solved my problem: I had the special Nordic letter æ ( a and e combined) in the file name.
I use a lot of different programs and did not come across that kind of problems since the DOS era. I can see in the other thread, that it has been known for a long time. Too bad.
It solved my problem: I had the special Nordic letter æ ( a and e combined) in the file name.
I use a lot of different programs and did not come across that kind of problems since the DOS era. I can see in the other thread, that it has been known for a long time. Too bad.
