pinched print
Posted: Mon May 06, 2019 6:17 pm
I have a flashforge creator pro and it has started to have an odd printing error.
The model shown is a straight cylinder, but after about 10 layers, the next 15-20 layers are slightly smaller, then it goes back to normal.
Does anyone have any idea what could be causing this? The machine is several years old, so it might be time to replace belts or something, but i'd ratherf not start replacing parts at random.
The model shown is a straight cylinder, but after about 10 layers, the next 15-20 layers are slightly smaller, then it goes back to normal.
Does anyone have any idea what could be causing this? The machine is several years old, so it might be time to replace belts or something, but i'd ratherf not start replacing parts at random.