Page 1 of 1

Dual Extrusion Printing Sequence

Posted: Tue May 14, 2019 11:55 am
by francesco
Dear All,

I have been using Simplify for many years without any issue, however recently i found that when printing in double material the default tool sequence is:

TOOL1
TOOL2
TOOL1
TOOL2
TOOL1
TOOL2

Instead of the more efficient:

TOOL1
TOOL2
TOOL2
TOOL1
TOOL1
TOOL2
TOOL2

The first sequece forces the printer to make a lot of tool changes and highly increases the risk of failure and the printing time.

Is there a way to use the second sequence instead? From memory the older versions of Simplify have the second sequence as default, am i wrong?

Re: Dual Extrusion Printing Sequence

Posted: Tue May 28, 2019 10:37 am
by francesco
Hi Everyone, any news about this item?