Posts: 3
Joined: Wed May 15, 2019 11:16 am

New Version not printing at all

Thu May 16, 2019 3:14 am

Since the last update to Simplify3d my printer prints nothing at all and I can't get any action from my extruder. Yet if I use Cura 3.5, it will print, though incorrectly. I'm running an Ender 3 with the TH3D version 2.10d firmware. Am I the only person that has run into this issue or could it be something entirely different? Doesn't matter if I'm using PLA or PETG.

Return to “Troubleshooting and Bug Reports”