davorin
Posts: 26
Joined: Wed Dec 27, 2017 1:25 pm

Will Print time estimates someday improve?

Mon May 20, 2019 9:16 am

Hello

Seen some older posts where people are telling that the print time estimate is off by 25% - 50%...

On my CR-10S I see that actual printing times are 25% - 33% longer on average....
Don't think that this high difference is only due to use the printer via USB serial...

The 4.1.0 release note states:
Print time estimates have been greatly improved by simulating the actual behavior of the printer firmware for increased accuracy
Maybe not all printers are including in this feature?


When printing over serial S3D knows exactly what it estimated and when the printing is actually finished....
so why not readjust the estimates based on previous printing times?


thanks for listening (o;
richard

Return to “Troubleshooting and Bug Reports”