alemaz
Posts: 2
Joined: Wed May 22, 2019 5:06 am

Simplify 4.1.1, supports problem

Wed May 22, 2019 5:15 am

Hi, I started using simplify recently and I have some problems with the supports. I read a bit on the forum of problems similar to mine but I did not understand if there is a solution or not. I am attaching photos of my settings and the slice he made. He pretends to print the support in the air, he does it also in other parts of the object. I don't know what to do and I don't know where to put my hand, the only value I tried to change is "extra inflation" lowering it but it doesn't change anything ... Can you give me a hand? I tried to print the piece anyway but it doesn't look good.


In the photos the part highlighted in orange is empty
1.jpg
2.jpg
3.jpg

alemaz
Posts: 2
Joined: Wed May 22, 2019 5:06 am

Re: Simplify 4.1.1, supports problem

Thu May 23, 2019 9:58 am

tomorrow I will add the missing photos, unfortunately i failed to put them in the first post

User avatar
dkightley
Posts: 2095
Joined: Tue Mar 10, 2015 4:09 pm

Re: Simplify 4.1.1, supports problem

Thu May 23, 2019 11:22 am

A factory file would be 10000000% more useful! Screenshots of partial settings can be hard to read.....and are likely to be useless to someone wanting to help.
Doug Kightley
Volunteer at the National Tramway Museum http://www.tramway.co.uk
Railway modeller and webmaster at http://www.talkingtgauge.net

Return to “Troubleshooting and Bug Reports”