Simplify 4.1.1, supports problem
Posted: Wed May 22, 2019 5:15 am
Hi, I started using simplify recently and I have some problems with the supports. I read a bit on the forum of problems similar to mine but I did not understand if there is a solution or not. I am attaching photos of my settings and the slice he made. He pretends to print the support in the air, he does it also in other parts of the object. I don't know what to do and I don't know where to put my hand, the only value I tried to change is "extra inflation" lowering it but it doesn't change anything ... Can you give me a hand? I tried to print the piece anyway but it doesn't look good.
In the photos the part highlighted in orange is empty
In the photos the part highlighted in orange is empty