3Dprinty
Posts: 6
Joined: Sun May 26, 2019 1:53 pm

Missing model parts and addition of non existing model parts?!

Sun Jun 09, 2019 6:35 pm

I tried to print this LEGO gear and noticed the following issues:

* The four spokes are missing
missing_spokes.jpg
all 4 spokes are missing
* A plane is added in the middle that doesn't exist in the original model
* The step inward of the four round holes gets printed with the perimeters first and thus gets printed in the air - supports are not generated either

The original model (t110.stl) comes from thingiverse:
https://www.thingiverse.com/thing:2765212

Nozzel: 0.4 mm
Extrusion width: 0.4 mm

Support generation is enabled but is not generated correctly?
Any advice on what's going wrong here?
Attachments
preview.jpg
sliced preview
model.jpg
original model

Return to “Troubleshooting and Bug Reports”