Page 1 of 1

LCD changes

Posted: Wed Jun 12, 2019 3:35 am
by losiledlighting
Hi,
I was tweaking my printer yesterday with one of the awesome prints from thingiverse. The way i was adjusting it was by using the LCD:

The question is:
Where I find the Flow rate which is dialed in at 200 on the LCD and my slicer extrusion multiplier is .94. How would i go about calculating the new extrusion multiplier.

Speed, on this setting I dialed the speed in at 80 rather than 100. How would i set this under the speed settings in the slicer.