losiledlighting
Posts: 2
Joined: Wed Jun 12, 2019 3:32 am

Can't Preview G-Code

Fri Jun 14, 2019 11:48 pm

I assume you figured this one out. Just slide the "End" slider to the right. The sliders let you show layer-by-layer or line-by-line how the printer will move, but the preview comes up with both sliders full left, which shows from the start of the print to the start of the print. Since "x minus x equals zero" nothing is shown. I added a "feature request" that the preview window come up as a default with the "Start" slider full left and the "End" slider full right, rather than both at full left, so the whole preview is shown and you don't have to DO anything to see it. Perhaps this will happen in 1.1.6...

TheBum
Posts: 103
Joined: Fri May 18, 2018 11:13 pm

Re: Can't Preview G-Code

Mon Jun 17, 2019 4:21 pm

Sounds like a setting in the software. All my previews come up with the min slider at minimum and the max slider at maximum.

Return to “Troubleshooting and Bug Reports”