jackheli
Posts: 5
Joined: Fri May 04, 2018 2:10 pm

Need help with setup

Wed Jun 19, 2019 4:50 pm

Hello,

I'm trying to print very thin one and two perimeter skins, but I keep getting these oozing thick strips of plastic, like spider arms. See picture.

Other than under extrusion, is there any setting I should play with?

I tried "Extra Retraction Distance" and then "Coasting Distance" but I had very little improvement.

Thank you for your help
Attachments
Streaks.jpg
Streaks.jpg

Return to “Troubleshooting and Bug Reports”