Page 1 of 1

Bug report: Missing outer layers

Posted: Sun Jul 07, 2019 6:49 pm
by charzander
SEE ATTACHED PHOTO AND ATTACHED COMMENT

I'm fairly certain this is a software issue. I'm sure the bed is level. I'm sure temperatures are consistent. I'm sure the filament has a clear path to the extruder.

What's happening here? I'm coming from Cura and new to Simplify 3D. Haven't had these issues before.

Re: Bug report: Missing outer layers

Posted: Mon Jul 08, 2019 11:12 am
by dkightley
There's nothing attached!

Re: Bug report: Missing outer layers

Posted: Mon Jul 08, 2019 8:43 pm
by charzander
Here's the attachment. However I fixed the issue. Turns out I DIDN'T have a clear path for the filament. It would eventually kink and cause layers to be missed. I tried to delete this post but couldn't find the button. Please disregard, thanks :)