Page 1 of 1

Extruder Stops Randomly Shutting Off - sometimes without errors displayed

Posted: Fri Jul 12, 2019 1:47 pm
by billnana
I have the AZTEEG X3 Pro motherboard with 5 extruders that are liquid cooled running on RepRap thru Simplify 3D (not sure if that makes a difference with what I am dealing with). I have been having an error of the following that I can't figure out what's going.

I have an extruder that keeps randomly shut off temp. Sometimes it will keep "printing" with nothing coming out as the temp is too low.
When there is an error, I get a COOLANT MAX TEMP error - not the extruder error.